Safe installation of baby changing tables
It is always recommended that only a carpenter or a qualified person to carry out installation of Hubble winding space station unit. Changing channels with plastics and metals interfere be built, thus insure two correct installation and compliance codes two buildings, winding space stations have to ask properly according to the manufacturer’s instructions.
Koala Kare ® Baby Changing Stations garden was tested two hold a static load of up to 400 pounds. Do this to do, ask the device must be installed correctly on the permanent wall that is capable of supporting so much weight, and can home to the supplied installation hardware. The Koala Kare ® Baby Changing Station meets ADA regulations when properly installed, the
mounting a vertical winding space stations.
1 Remove the transmitter from the box and see if shipping damage. Identify the best location for the installation of the winding space station. Keep the unit there, then open the bed and make mad that an adequate safety margin.
2 Based on the type of wall Wed, install the unit goodwill ask to deter me the best method of installation. Not all the included hardware May for the proper installation needs.
3 The vertical unit ha four holes in the back of the device are provided which are positioned on a 16 “stud center. If possible, find wood or metal wall studs for fastening the winding space station at the desired location. the walls are not studs Wed garden center as outlined to the acid at least one side of the unit is installed, the Into the stud. Use switch (supplied) for holes on the other side.
4 Find the stud Why do you ask the goodwill associated the left side of the changing station two of the wall. measure 63 “from the floor (59″ ADA), in the middle of the bolt, and mark the wall. Align the top-left mounting hole with this mark, simply use a tape measure and level two mark the remaining three holes. This goodwill locate the bottom of the station 31 from the floor (27 “ADA).
5 . If the wall ha wood post Wed 1916 “centers, drill 1 / 8″ holes at the marks and the four ¼ “x 3″ panhead screws with washers. If the wall is masonry or tile over wood studs, with a 7 / 32 ” masonry drill until the stud just Go with 1 / 8 drill hit “pilot holes into the tunnels and the four 1 / 4″ x 3 “screws with supplied washers.
For more information VisitSweden this website http : / / www.baby-changing-stations.com
Themocracy